Standard Rifle Specifications
- Collapsible 6 position M4 stock
- Matched, forged, flat top upper and lower receivers
- Barrel hand-lapped to upper receiver for accuracy
- Mil-spec fire control parts
- Removable A2 rear sight
- M-16 bolt carrier with properly staked gas key
- MP (Magnetic Particle) & HPT (High Pressure Tested) bolt
- M4 feed ramps
- 16 inch, 1:7 twist, chrome lined, 4150, M4 profile barrel
- A2 sight block properly pinned with 2-0 taper pins
- A2 flash suppressor
- Mil-spec anodized upper and lower finish
- Mil-spec parkerized barrel
What makes the PSD-15 rifle a shot
above the rest?
First off, the PSD-15 rifle is not built in a factory on an assembly line. Each PSD-15 is hand built by skilled professionals in a precision machine shop environment in upstate South Carolina. This means that EVERY PSD-15 rifle is built to a higher standard using the highest quality parts and materials available. The PSD-15 is our "basic" M4 styled AR. We go the extra mile by adding "the little things" here and there that you normally won't find on a standard production M4. Along with our standard rifle we also offer an MOE version (Black, FDE or OD Green) and the piston driven, SRC (suppressor ready carbine).
Barrel Information
Standard PSD-15 Rifles come equipped with a 1:7 twist, chrome lined barrel capable of firing bullets weighing 55 to 77 grains. Our barrels are hand lapped to the upper receiver after anodizing to remove any high spots and inconsistencies. To achieve the best results for accuracy you should clean the chamber and bore after every round for the first 30 rounds, then every 10 rounds up to 100 rounds. It usually takes about 200 rounds per barrel for optimum barrel break-in and accuracy. Accuracy is dependent upon many factors such as bullet weight, powder load, rifling twist rate, operator technique, environmental conditions, etc. Our production barrels have achieved anywhere from .125" to 1.5" M.O.A.. Obviously, we would hope that every production barrel would shoot Sub-M.O.A., but with all of the above factors, we cannot guarantee a specific group size. PLEASE NOTE: Using reloaded ammunition will void warranty. Modifying chamber or barrel voids warranty. This includes re-reaming of chamber, re-turning barrel to a lesser diameter and/or rethreading barrel for compensator or attachments.
